One simple method of getting your foot in the door is to check out Craigslist help-wanted ads. It’s about the only place I’ve seen a decent selection of job postings for woodworking, and some are entry-level positions. Once a little experience with basic tools is acquired, more options open up. However, a lot of the most interesting positions can’t be found by searching jobs postings. Many high-end furniture shops recruit via networking instead of advertising for help. To break into the custom furnishings market, do research to find out who is doing the sort of work you’d like to get into, then figure out what circles they participate in. If they belong to a particular artist association, try to attend their shows or get an introduction to one of the members. If they teach classes, attend their classes. The goal is to get their attention, and let it be known you wish to pursue a woodworking career. Demonstrate good work ethic, reliability and a willingness to learn, and someone might take notice. Talk to people and continue to introduce yourself to others.
As projects increase in size and scale, there is usually a desire to get a larger table saw, a miter saw, add a small jointer, a router and maybe a belt sander. Eventually, things get out of hand and you are seen at every tool sale, and spend more time online looking at the few remaining tools for which you have not yet found a project that will justify their purchase.
Apply 2 coats of Urethane with a brush. Let the second coat dry completely (6-12 hours), then lightly sand the armrests, table, and areas you come in contact with when sitting (chair slats). This light sanding with 220 grit paper will remove any dust particles that settled in the first coat. Next, take a clean cloth and wipe a thin coat of poly on all the areas you sanded. This will give you a nice smooth finish. Once dry, enjoy your new furniture and have a barbecue!
A wall-bed combination or drop-down bed helps save a lot of room in a tight basement, so consider installing this Murphy bed and bookcase. It’s one of many great basement bedroom ideas. Further, a Murphy bed can be super simple: Some are just an upright box that contains a folddown bed. But this is a deluxe version because it includes ample storage.
A marking knife is used for marking where you will be cutting with your saws. For getting into tight spots (like dovetails) and making very accurate lines (which is vital for tight fitting joints) you need just the right marking knife. You would think that any old knife would work, but you would be wrong. Years ago I purchased several that didn’t work well.
But until then, I’ve been thinking of other ways to use my hands and create things. (Even though many of our saws and tools have been stolen.) But I’m feeling a little antsy to make some quick projects, because creating makes me extremely happy…..so we’re calling this surge in me to create something simple, THERAPY. In fact, I need to call up a few friends and have them make some with me because friends and creating is a favorite combo of mine! (Any out of town-ers want to fly in?! ;) )
Thank you for that info. Is there any recommended size for crosscutting? Lets say I purchase a 4×8 sheet of plywood or MDF at my local home center. I have them cut it down to strips of 18×8 (for example). When I get home, if I need to crosscut the 18×8 piece, is that possible on a cabinet saw with a crosscut sled or better with a track saw? Reason I ask, that will most likely be my scenario when I purchase lumber. I would rarely bring home a full 4×8 sheet from the store because it’s easier to transport it in smaller widths. I’m at the point to make some tool purchases, and seeing if I should go solely with a track saw for my scenario or get both? I do have a 12 inch compound miter saw but cutting to size on that with 18 inch depth panels is hard in one pass.